| 1. | Thermic electromotive force and allowable error at 200 mv
200热电动势及允差mv |
| 2. | Thermic electromotive force and allowable error at 100 mv
100热电动势及允差mv |
| 3. | Allowable error for judge of quality testing results in feeds
饲料检测结果判定的允许误差 |
| 4. | 1 . thermic electromotive force and allowable error
1 .热电动势及允差值 |
| 5. | Analysis of error sensitivity and allowable error of optical film , and computer controll in production
光学薄膜的误差允差分析及生产过程中的计算机控制 |
| 6. | The best parameters , precision grades and allowable errors of the transmission parts can be obtained by optimization to let the actuators meet the performance , technology and economy requirements simultaneously
根据传动精度指标，最佳地规定和分配各传动零件参数、精度等级及公差值，使之满足设计、工艺要求。 |
| 7. | It is also shown that the allowable errors for section dimension are loose and the allowable errors for axis line deviations are suitable in the " code for acceptance of constructional quality of concrect structures " ( gb50204 - 2002 ) . in the fifth chapter : the conclusion and the outlook
统计分析表明， 《混凝土结构工程施工质量验收规范》 ( gb50204 - 2002 )中关于结构截面尺寸的允许偏差是较宽松的，而对轴线位移的允许偏差基本是合理的。 |
| 8. | Arranging velocity and acceleration sensors simultaneously in the same station , in the identical round of holes , under the condition of the same sample frequency , the differential values of velocities should tally with the actual measurement values of acceleration or be in the range of allowable error
摘要在同一测点同时布置了速度和加速度传感器，在同一炮次中，在同样的采样频率情况下，速度值求导应该与实测加速度相吻合或在误差允许范围内。 |
| 9. | Feedrate planning of continuous micro - line ' s start and end points are discussed , and the constraining conditions , including the machine ' s acceleration and deceleration capability , allowable error of corner machining , maximum acceleration and dynamical behavior of the machine , are established 。
摘要针对连续小直线段高速高精插补算法中起始点和终止点的速度规划，建立了包含机床加减速性能、转接处误差控制、最大加速度以及机床负载功率等的速度约束条件。 |
| 10. | When the silicon technology comes to deep sub - micron level , the interconnect delay exceeds the gate delay ; and because of the increase of 1c work frequency , the allowable errors become smaller , and the influence of the transmission delay gets bigger , which increase the difficulty of the circuit design
在深亚微米制造技术中，芯片互连线延迟超过门延迟，而且随着集成电路工作频率的提高，允许的时序容差变小，传输延迟的影响加大，设计工作难度增加。 |
